TABLE OF CONTENTS Page 1. RF ENERGY EXPOSURE INFORMATION......4 RF ENERGY EXPOSURE AWARENESS, CONTROL INFORMATION, AND OPERATION INSTRUCTIONS FOR FCC OCCUPATIONAL USE REQUIREMENTS ..4 1.1.1 Federal Communications Commission Regulations..5 COMPLIANCE WITH RF EXPOSURE STANDARDS ..5 1.2.1 Mobile Antennas ............6 1.2.2 Approved Accessories..........6 1.2.3 Contact Information...........7 2.
RF ENERGY EXPOSURE INFORMATION RF ENERGY EXPOSURE AWARENESS, CONTROL INFORMATION, AND OPERATION INSTRUCTIONS FOR FCC OCCUPATIONAL USE REQUIREMENTS Before using your mobile two-way radio, read this important RF energy awareness and control information and operational instructions to ensure compliance with the FCC’s RF exposure guidelines. This radio is intended for use in occupational/controlled conditions, where users have full knowledge of their exposure and can exercise control over their exposure to...
1.1.1 Federal Communications Commission Regulations Your M/A-COM, Inc. EDACS D3100 RF Modem is designed and tested to comply with the FCC RF energy exposure limits for mobile two-way radios before it can be marketed in the United States. When two-way radios are...
1.2.2 Approved Accessories This radio has been tested and meets the FCC RF guidelines when used with the M/A-COM accessories supplied or designated for use with this product. Use of other accessories may not ensure compliance with the FCC’s RF...
For a list of M/A-COM approved accessories refer to the product manuals, M/A-COM’s Products and Services Catalog, or contact M/A-COM at 1-800- 368-3277. 1.2.3 Contact Information For additional information on exposure requirements or other information, contact M/A-COM, Inc. at 1-800-528-7711 or at http://www.macom-...
2. SAFETY INFORMATION COMMON HAZARDS The operator of any mobile radio should be aware of certain hazards common to the operation of vehicular radio transmissions. Possible hazards include: • Explosive Atmospheres Just as it is dangerous to fuel a vehicle with the motor running, be sure to turn the radio OFF while fueling the vehicle.
3. INTRODUCTION This manual describes how to program, install, and use the M/A-COM ® EDACS D3100 Data RF Modem. The EDACS D3100 Data Modem is a data-only mobile or fixed-station radio used in the Enhanced Digital Access Communications System (EDACS) trunking environment systems.
4. DESCRIPTION D3100 comes ready to connect into a system with a personality containing two systems. The power-on default system is an EDACS Data System named “Site” containing an EDACS Control Channel (806.075 TX/851.075 RX) and an EDACS Working Channel (820.975 TX/865.975 RX). The second system is named “851”...
DATA CONNECTOR FUNCTIONS The data connector on the D3100, in shape and form, is similar to the “option connector” of the E500M Mobile Radio made by M/A-COM. The following pinouts and drawing define the cable and connections. DATA CONNECTOR (J1) PIN ASSIGNMENTS (DB-25-Socket) (Pin # - Pin Function) 15.
5. OPTIONS AND ACCESSORIES Table 5-1: EDACS D3100 RF Modem Options and Accessories DESCRIPTION PART NUMBER D3100 Test Box TS103114V1 Roof Top Antenna AV102800V1 Yagi, 8dBd, Fixed-station Antenna AN103358V1 Control Unit, Orion, Scan, D2CP5L KRY 1011632/12 Data/Programming C-U Adapter Cable...
6. INSTALLATION UNPACK AND CHECK THE EQUIPMENT Before starting the installation, carefully unpack the equipment and inspect the equipment for damage. If there is any damage, file a claim with the carrier immediately. POWER CABLE DATA CABLE D3100 UNIT Figure 6-1: D3100 Unit PLAN THE INSTALLATION Before starting, plan the modem’s installation carefully so that it will be: •...
If installation is within the United States, it is recommended the unit be installed by one of the many M/A-COM Authorized Service Centers located throughout the U.S. Personnel at these centers are experienced in installations of this type and can provide a safe, neat, and functional installation.
Equipment covered under Paragraph B.3 and B.4. To be eligible for no-charge labor, service must be performed at a M/A-COM factory, by an Authorized Service Center (ASC) or other Servicer approved for these purposes either at its place of business during normal business hours, for mobile or personal equipment, or at the Buyer’s location, for fixed location equipment.
Need help?
Do you have a question about the EDACS D3100 and is the answer not in the manual?
Questions and answers