M/A-Com M7100IP Series Installation Manual page 55

b. Select any M7100
programmed. The M7100
with "multi-radio" set to "Master" in a dual radio personality.
3. Program the unit normally. Include Extended Option features, if purchased.
4. Program the Slave Unit (refer to the programming configuration that
follows).
a. Now configure the Slave Radio Unit for programming. Be sure to use
the programming configuration for remote mount and supply the
required control unit if for a front/remote mount dual radio
configuration.
b. In the "Multi-Radio" field of ProGrammer, select "Slave."
5. Program the unit normally. Do NOT include Extended Option features.
Both radio units are now ready for vehicular installation.
Programming Configuration
Dual Control
Speaker
Multiple Radio
Radio Type
Power Up Volume
Mute Time-Out
Termination
Display
Power Up
Power Up Radio
Receive Emergency
Receive Only
MuRPS
Program Radio Setup
Mobile Options
IP
M7100 Options
Write System Keypad File
Write Scan Keypad File
IP
keypad programming options if the keypad is to be
IP
keypad options can only be programmed
Disable
Disable
Enable
Slave or Master
5
30.0
Enable
Selected for Master radio only
Enable for Master radio only
Master for Master radio only
Enable for Master radio only
Enable for Master radio only
Disable for Master radio only
Push Button
Enable (System control unit)
Enable (Scan control unit)
55