M/A-Com M7100IP Series Installation Manual page 34

Figure 19 – Mounting Bracket Installation
6. Connect front mount accessory cable connector P2 to speaker cable
connector.
7. Connect power cable to power connector on rear of radio unit and secure
with the two captive screws to the radio unit.
8. Connect the microphone connector to the connector on the front panel
and secure with the captive screw.
Do not torque the microphone connector screw greater
than 2 in-lb. Alternatively, "finger tight plus 1/4 turn" is
acceptable.
NOTE
9. If there are no other accessory connections, tie back plug P3 to main
cable.
10. Recheck all connections before inserting fuse into transmit fuse assembly.
Remote Mount Installation
The bracket shown in Figure 20 is used in Remote Mount configurations. In
some applications, the bracket shown in Figure 19 can also be used for
34