M/A-Com M7100IP Series Installation Manual page 57

4. Connect "IGN A+" lead, if option is desired. Be sure internal Switch SW601
on Master Radio is set properly. Refer to Page 25 of this manual for details.
5. Connect Accessory Cable (19B802554P7) Connector (P1) to Control Head.
6. Connect the Microphone and Accessories. Refer to Accessory Installation
Manual for proper connection of Accessories.
7. Now, connect Remote Control Cable Connector (P1) to the Dual Radio
Cable Connector (P2), and tighten to jackscrews on P2.
8. Connect Power Cable, and Antenna, then install Master Radio Unit in
mounting bracket.
9. After installing Slave Radio Unit in its mounting hardware, connect Dual
Radio Cable (P1), and tighten jackscrews. Be sure SW601 setting on Slave
Radio Unit is same as for Master Radio Unit. Connect Power Cable and
Antenna to Slave Radio.
10. Check Dual Radio operation, using operator's manual as test guide.
IP
Figure 31 - M7100 Dual Radio Front Mount/Remote Mount Installation
Configuration
57