1. Configure the M7100
shown in Figure 29, Step 1 with Control Unit #A disconnected. Program
the radio with the control configurations shown in Step 1 of "Pre-
Installation Programming Procedure with ProGrammer – Remote Mount"
and adjust as necessary for the specific application.
2. Now configure the Remote Mount Radio and Auxiliary Control Unit per
ProGrammer setup as shown in Figure 29, Step 2, with Control Unit #A.
Program the configurations shown in Step 2 of "Pre-Installation
Programming Procedure with ProGrammer – Remote Mount" and adjust
as necessary for the specific application.
IP
Remote Mount Radio per ProGrammer setup as
51