M/A-Com M7100IP Series Installation Manual page 49

Field Programming Procedure - Dual Control Units –
Front/Remote Mount Configuration
The Radio and Control Units must be programmed in a sequential procedure
in order to provide each Control Unit with the proper identification code.
1. Configure the M7100
Unit per the ProGrammer setup as shown in Figure 28, Step 1 with
Control Unit A disconnected.
configurations shown in Step 1 of "Pre-Installation Programming
Procedure with ProGrammer – Front Mount" and adjust as necessary for
the specific application.
2. Now configure the Front Mount Radio and Auxiliary Control Unit per
ProGrammer setup as shown in Figure 28, Step 2 with Control Unit A
reconnected. Program the configurations shown in Step 2 of "Pre-
Installation Programming Procedure with ProGrammer – Front Mount"
and adjust as necessary for the specific application.
IP
Front Mount Radio and the Auxiliary Control
Program the radio with the control
49