Antenna - M/A-Com M7100IP Series Installation Manual

Hide thumbs Also See for M7100IP Series:
Table of Contents

Advertisement

ANTENNA

Installation instructions for the antenna are packaged with the antenna. The
antenna must be installed in accordance with good engineering practice for
optimum results.
Typical Mobile Antenna Installation
A permanent mount-type antenna must be located in the center of the roof.
See the "RF ENERGY EXPOSURE INFORMATION"
section at the beginning of this manual for further
information regarding Maximum Permissible Exposure
(MPE) limits of RF radiation absorption set by the
WARNING
FCC.
Try to route the antenna cable away from locations where it will be exposed to
heat, sharp edges or mechanical damage, and where it will be out of the way
of the driver, passengers or vehicles mechanics. Wherever possible, existing
holes in the trunk wall, and the channels above or beneath doors and window
columns should be utilized.
Avoid routing the antenna cable near any electronic modules or along side
any vehicle wiring.
Connect the antenna cable to the TNC on the radio, being careful not to twist
the cable.
63

Advertisement

Table of Contents
loading

Table of Contents