Microphone Hanger And/Or Hookswitch Mounting; Siren And Light - M/A-Com M7100IP Series Installation Manual

1. Use the mounting bracket as a template for locating the mounting holes
and mount the speaker as shown in Figure 18.
2. Refer to the applicable installation procedures for connection of the
speaker to the accessory cable.
MICROPHONE HANGER AND/OR HOOKSWITCH
MOUNTING
The microphone hanger or hookswitch should be mounted in a location
convenient to the operator where it will not interfere with the safe operation of
the vehicle or be a hazard to the vehicle passengers. The hanger and
hookswitch are designed to be mounted with the open end of the mounting
button slot pointed upward. Use the hanger or hookswitch as a template to
mark and drill the mounting holes. Mount the hanger or hookswitch with the
self-tapping screws provided.
Figure 18 – Speaker Mounting Bracket

SIREN AND LIGHT

For instructions about installing the Federal Signal Corporation Siren and
Light Kit, refer to the Federal Signal Corporation Installation Instructions
(Federal Systems part number 255287B, rev. B or higher).
Program the radio to work with the Federal Systems Siren and Light Kit,
using the instructions outlined in the ProGrammer On-Line Help.
NOTE: The following issues have been reported on some M7100
Siren/Light installations using the Federal Signal Corporation Siren and Light
Kit:
•
Occasional false activation of siren and light functions when the ignition
is turned to the "on" position and/or when the vehicle is started.
32
IP