EQUIPMENT REQUIRED
The equipment required for installing the M7100
listed below:
•
Crimping tool for fuse holder
•
Electric drill for drilling mounting holes
•
Drills and circle cutters, as follows:
No. 31 (1/8-inch) drill
No. 27 (9/64-inch) drill
5/8-inch drill or circle cutter
3/4-inch circle cutter, hole saw or socket punch
•
Phillips and flat-blade screwdrivers
•
®
POZIDRIV
driver
•
®
No. 20 Torx
driver
Be careful to avoid damaging some vital part (fuel tank,
transmission housing, etc.) of the vehicle when drilling
mounting holes. Always check to see how far the
mounting screws will extend below the mounting surface
CAUTION
before installing.
If pilot holes must be drilled, remove all metal shavings
from drilling holes before installing screws.
CAUTION
IP
Series Mobile Radio is
19