Remote Mount installations. The following instructions are for a Remote
Mount installation using the bracket shown in Figure 20.
Figure 20 – Remote Mounting Bracket Installation
1. Using the bracket as a template, mark and drill the mounting holes using
a No. 27 drill. Be sure to leave enough room at the rear of the radio unit
for the cable connections.
2. Secure the mounting bracket using four 1/4"-14 x 3/4" sheet metal screws
(use 1/4"-14 x 1" if needed.) The bracket can be used mounted so that it
is either above or below the radio for the user's convenience.
3. Slide the radio unit into the bracket by aligning bracket guides with
grooves on each side of radio (rear of radio should be inserted first).
Slide radio back until screw holes in front of bracket align with screw
holes in side of radio. See Figure 20.
4. Secure radio to the bracket with two M4 x 10 mm socket head screws
provided.
35