Installation Instructions For Front Mount Dual Control Units - M/A-Com M7100IP Series Installation Manual

Note that the Main Control Unit has ID "A" and Auxiliary Control Unit has
ID "B" in this configuration.
IP
Figure 23 – M7100 Dual Control Unit PC Programming Configuration
INSTALLATION INSTRUCTIONS FOR FRONT MOUNT
DUAL CONTROL UNITS
The Dual Control Unit feature is configured such that only one control unit
can be used for Extended Option accessories. All Extended Option functions
are only available at the Main Control Unit.
1. Referring to Figure 24, run the Dual Control Cable (19B802554P9)
between locations for the Radio Unit and Auxiliary Control Unit. Be sure
to locate the P2/P3 connector assembly at the Radio Unit.
2. After installing Radio Unit mounting hardware in the normal fashion,
connect the Dual Control Cable connector (P3) to the Radio Unit. Tighten
the two jackscrews on P3. Next, connect the Accessory Cable
(CA101288V2) Connector (P1) to the Dual Control Cable Connector
(P2), and tighten the jackscrews on P2. Connect the power cable, and
install Radio Unit in mounting bracket.
42
Remote Mount