Steering Post/Handlebar/Tie Rods - Arctic Cat 2016 90 Utility Service Manual

9. Install the handlebar cover with two cap screws and
push pin, and connect the one 4-pin connector and
two 2-pin connectors. Connect both 2-pin headlight
connectors.
10. Install the footwells with the Phillips-head screws
and cap screws.
11. Route the CDI connector, main relay, and main fuse
case through the plastic and connect the CDI unit.
Install all three into their locations.
YT223
12. Set the battery in place and first connect the positive
cable then the negative cable. Install the battery
bracket.
CAUTION
Check for proper hydraulic and brake cable operation.
Adjust as necessary. Check for proper throttle cable
operation. Start the vehicle and check for any signs of
fuel leakage. Repair as needed. Verify all electrical com-
ponents are operational.
Steering Post/Handlebar/
Tie Rods
REMOVING
1. Remove the seat.
2. Remove the control cables from the handlebar; then
route them through the metal loop on the steering
post and out of the way.
YT226
MD2431
3. Remove the handlebar cover, bracket, and the han-
dlebar.
MD2139
4. Disconnect the handlebar switch assembly and brake
switch connectors; then route them through the metal
loop on the steering post and out of the way.
YT218
5. Remove the cap screws securing the body panel. On
the Utility, remove the front and rear racks.
6. Remove the gas tank cap and lift off the main body
panel (see Gas Tank in Fuel/Lubrication).
17