Removing The Units - Omron E3X-DRT21 Operation Manual

Mounting
5-1-2

Removing the Units

1,2,3...
100
3. Connect the Fiber Amplifier Units to the Communication Unit side by side
by sliding the Fiber Amplifier Units until the clips on the end and the clips
on the Connector are aligned with the Communication Unit and a "click"
sound is heard.
Fiber Amplifier Sensor
Communication Unit
4. Use PFP-M End Plates (order separately) to secure both ends.
End Plate
Note Use the correct procedure to mount the Units, performing step 1 before step
2. Reversing these steps may reduce the mounting strength.
Correct
Mounting point 1 before point 2 is
the correct order.
Use the following procedure to remove the Units.
1. Slide the Fiber Amplifier Units away from the Communication Unit to dis-
connect them.
Fiber Amplifier Units
Incorrect
Do NOT mount point 1 before
point 2.
Section 5-1