Table of Contents
Advertisement
Connecting Fiber Amplifier Units
1-3-3
Supported Fiber Amplifier Units
1-3-4
Slave Connectors for Fiber Amplifier Units
8
The Communication Unit can be connected to the following Fiber Amplifier
Units.
Model
number
E3X-DA6
Standard model NPN
E3X-DA8
E3X-DA6-P
ON/OFF inci-
dent light level-
monitoring
model
(See note 1.)
E3X-DA6TW Twin-output
model
E3X-DA8TW
E3X-DAB6
Mark-detecting
model
E3X-DAB8
(blue LED)
E3X-DAG6
Mark-detecting
models
E3X-DAG8
(green LED)
E39-TM1
Terminal Block
Unit
Note
1. The incident light level can be monitored when Unit is turned ON or OFF.
2. Prewired Units (E3X-DA11/21/41/51-N, E3X-DAB11-N, etc.) and Water-
resistant Units (such as E3X-DA14V) cannot be used. Connecting these
Units will disable the power reset switch.
3. Connections of E3X-DA6/8, E3X-DAB6/8, E3X-DAG6/8, E3X-DA6TW, and
E3X-DA8TW are restricted depending on the lot number. Refer to page 6
for details on restrictions.
4. Install the E39-TM1 Terminal Block Unit as far away from the Communica-
tion Unit as possible.
Fiber Amplifier Units must be used with Slave Connectors (purchased sepa-
rately). When connecting a Fiber Amplifier Sensor Communication Unit, how-
ever, the Slave Connector that can be connected to the Fiber Amplifier Unit is
restricted according to the Communication Unit used, as shown in the follow-
ing table.
Fiber Amplifier Sensor
Communication Unit
E3X-DRT21 (DeviceNet)
E3X-SRT21 (CompoBus/S) Yes
E3X-CIF11 (RS-422)
Note Do not use a E3X-CN11 or E3X-CN21 Master Connector with a Fiber Ampli-
fier Unit.
Unit type
Output
type
PNP
NPN
NPN
PNP
NPN
PNP
NPN
PNP
NPN/PNP ---
(Yes: Can be used; No: Cannot be used)
Slave Connector for Fiber Amplifier Unit
Cordless
E3X-CN02
Yes
Yes
Section 1-3
Monitor
Number of
output
thresholds
unit numbers
None
1
1
2
2
1
1
---
With 1-wire cord With 2-wire cord
E3X-CN12
E3X-CN22
No
No
No
No
Yes
No
Number of
allocated
Advertisement
Chapters
Table of Contents
Troubleshooting
