Ricoh RN-MF2 Field Service Manual page 179

Message
The Scan to USB function failed
Failed to Access
because the machine could not
File
access the USB flash disk
Press Clear key
properly.
Failed to Create
The Scan to USB function failed
File
because there was not enough
memory on the USB flash disk.
Press Clear key
The number of fax jobs in memory
Fax Job Memory
(unsent or unprinted faxes) has
reached maximum, so new jobs
Overflow
cannot be stored.
Connection to the POP3 server
I-Fax POP3 fails
failed.
Indep.Sply.Prt.Cart.
A non-supported print cartridge is
installed.
Internal Misfeed Paper has been jammed in the
machine.
Memory Almost
Full
Memory has almost reached
capacity during sort copy.
Causes
Use a USB flash disk that is not password-
or write-protected.
Use a USB flash disk with enough memory.
Wait until pending jobs have been
transmitted or printed.
• Confirm that the network cable is
• Confirm that the network settings such
Remove and replace it with a print
cartridge specified by an authorized
dealer.
Remove the jammed paper. See the user's
guide.
If several originals are still to be scanned,
it is recommended to start printing now,
and copy the remaining originals
separately. If originals are being scanned
from the ARDF or ADF, remove any
remaining pages from the ARDF or ADF.
Solutions
properly connected to the machine.
as IP address, DNS, and POP3
settings have been configured
properly (make sure that no double-
byte character is used). See the user's
guide.
Error Messages
19