Ricoh RN-MF2 Field Service Manual page 118

5. System Maintenance Reference
Fax Maintenance
Protocol Definition
Protocol Definition Timer
RX Settings
116
This sets the number of training retries to be
repeated before automatic fallback.
Training Retries
[1 Time/ 2 Times (Default)/ 3 Times/ 4 Times]
Sets the compression method for Tx/Rx.
Encoding
[MMR+MR+MH (Default)/ MR+MH/ MH]
Timeout for response from the called station in
automatic sending mode
T0 Timer
[35 Sec/ 45 Sec/ 55 Sec / 60 Sec (Default)/ 90
Sec/ 140 Sec]
Set the time length for the T1 timer.
T1 Timer
[40 Sec (Default)/ 50 Sec]
Set the time length for the T4 timer.
T4 Timer
[3 Sec (Default/ 4.5 Sec]
Silence (No tone) detection time (Rx mode : FAX/
TAD Only)
Silence Detection After the line is connected via the external
Time telephone, the machine can detect silence (no tone)
for the time length specified by this setting.
[30 sec (Default)]
CNG tone detection time ( RX mode : FAX / TEL,
FAX / TAD Only)
CNG Tone After the line is connected via the external
Detection telephone, the machine can detect a CNG signal
for the time length specified by this setting.
[5 Sec (Default)/ 10 Sec]
Number of CNG cycles to be detected
CNG Cycles This setting is only effective for FAX/TAD mode.
[1.5 Cycle (Default)/ 2.0 Cycle]