Ricoh RN-MF2 Field Service Manual page 110

5. System Maintenance Reference
Engine Maintenance
Registration
Registration
108
Adjusts the horizontal registration for the bypass tray. If the
machine settings are reset to the factory defaults, this value
Horiz Bypass tray
does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of plain paper for the bypass
tray. If the machine settings are reset to the factory defaults,
Vert Bypass Plain
this value does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of thick paper for the bypass
tray. If the machine settings are reset to the factory defaults,
Vert Bypass Thick
this value does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of thin paper for t the bypass
tray. If the machine settings are reset to the factory defaults,
Vert Bypass Thin
this value does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the horizontal registration the back side in duplex
mode. If the machine settings are reset to the factory
Horiz. Dup. Back
defaults, this value does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of plain paper for the back
side in duplex mode. If the machine settings are reset to the
Vert. Dup Back
factory defaults, this value does not change.
Plain
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of thick paper for the back
side in duplex mode. If the machine settings are reset to the
Vert. Dup Back
factory defaults, this value does not change.
Thick
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of thin paper for the back
side in duplex mode. If the machine settings are reset to the
Vert. Dup Back Thin
factory defaults, this value does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]