Table of Contents
Advertisement
5. System Maintenance Reference
Fax Maintenance
Tone Signal Settings
1Dial Tone Detection
118
Sets the tone signal transmission time length
Tone Signal
Transmission T
[100 ms (Default)]
Sets the minimum pause during tone dialing
Minimum Pause In
Tone Dial
[100 ms (Default)/ 150 ms/ 200 ms]
Sets the attenuator for pseudo ringback tone to the
Attenuator of
line
Pseudo Ring
[0 to 15 / 10 (Default)/ 1 dB/step]
Sets the transmission level of DTMF tones.
DTMF Level
[-12 dBu / -11 dBu/ -10 dBu (Default)/ -8 dBu/
-6 dBu]
Sets the level difference between high band
frequency signals and low band frequency signals
DTMF Delta
when sending DTMF tones.
[2 dBu/ 3 dBu]
The machine starts dialing after the specified
interval without detection of a dial tone when
Dial tone detection is set to "No detection".
Wait Time
[3.5 Sec (Default)/ 7.0 Sec/ 10.5 Sec
/ 14.0 Sec]
This setting sets the time-out length for the 1st dial
tone detection. The machine waits for a dial tone
for the specified time and disconnects itself from the
Timeout Length
line when no dial tone is input.
[10 Sec (Default)/ 15 Sec/ 20 Sec/ 30 Sec]
Advertisement
Table of Contents
