Mounting - ABB AX416 User Manual

...6 INSTALLATION

...6.2 Mounting

6.2.2 Panel-mount Analyzers – Figs. 6.4 and 6.5
Dimensions in mm (in.)
96 (3.78)
5.40 (0.2)
Cut a hole in the panel (see Fig. 6.4 for dimensions).
1
Instruments may be close stacked to DIN 43835
Refit the panel clamps to the case, ensuring that the
5
panel clamp anchors are located correctly in their slots
Secure the analyzer by tightening the panel clamp
6
retaining screws (see
Note. The clamp must fit flat on the analyzer
casing. If the clamp is bowed, the securing screw is
overtight and sealing problems may occur.
46
Fig. 6.4 Overall Dimensions
Remove the panel clamp and
anchors from the instrument case
Loosen the
2
retaining screw on
each panel clamp
below)
Note
Fig. 6.5 Panel-mounting
25
137.50 (5.41)
(0.98)
3
+0.8 +0.03
92 (3.62 )
–0 –0
+0.8
92
–0
Panel Cut-out
+0.03
(3.62 )
–0
Insert the instrument
4
into the panel cut-out