Adjust Offset (Redox/Orp Only) - ABB AX416 User Manual

...4 SETUP
...4.1 Sensor Calibration

4.1.3 Adjust Offset (Redox/ORP Only)

-----
Sensor Cal. A
0
mV
407
mV
A: Adjust Offset
Sensor Cal. A
22
Calibrate Sensor A
Sensor B (dual input analyzers only) calibration is identical to Sensor A
Sensor Cal. B
calibration.
for Sensor B (dual input analyzers only) set to
Probe Type
SENSOR CAL.
set to
Enable Cals.
Alter Sec. Code
SECURITY CODE
CONFIG. DISPLAY Alter Sec. Code
set to
Probe Type
A: Adjust Offset
set to
A: Buffer Method Probe Type
Adjust Offset (ORP/Redox probes only)
and are shown alternately on the upper display line. Use the
mV Adjust
adjust the upper display line to the required offset value for the process.
Sensor B (dual input analyzers only) calibration is identical to Sensor A
Sensor Cal. B
calibration.
for Sensor B (dual input analyzers only) set to
Probe Type
SENSOR CAL.
set to
Enable Cals.
Alter Sec. Code
SECURITY CODE
CONFIG. DISPLAY Alter Sec. Code
(Section 5.3) – return to top of page.
No
not set to zero (Section 5.8) – see Section 5.1.
set to zero (Section 5.8) – see Section 5.2.
or (Section 5.3) – continued below.
Redox ORP
(Section 5.3) – see Section 4.1.4.
pH
(Section 5.3) – return to top of page.
No
not set to zero (Section 5.8) – see Section 5.1.
set to zero (Section 5.8) – see Section 5.2.
or
Redox ORP and
and keys to
or
Redox ORP and