ABB AX416 User Manual page 32

...5 PROGRAMMING
5.3 Configure Sensors
-----
CONFIG. SENSORS
-----
Config. Sensor A
ORP
Redox
-----
pH
A: Probe Type
Yes
-----
No
A: Diff. Input
A: Probe Type
set to
Redox/ORP
None
3K Bal
Pt1000
-----
Pt100
A: Temp. Sensor
Yes
-----
No
A: Enable Cals
Config. Sensor A
30
Configure Sensor A
Sensor B configuration (dual input analyzers only) is identical to Sensor A
Config. Sensor B
configuration.
Probe Type
Select the required probe type.
ORP – Millivolt display
Redox – Millivolt display
pH – pH display
Differential Input
Yes – Select if electrode system is equipped with a solution earth (ground) rod and
sensor diagnostics are required – see Section 5.4.
No – Select if electrode system is not equipped with a solution earth (ground) rod
or sensor diagnostics are not required.
Note. Ensure the electrode system is connected correctly for the type of input selected
(Standard or Differential) – see Fig. 6.9 (wall-/pipe-mount analyzers) or Fig. 6.11 (panel-
mount analyzers).
set to
A: Temp. Sensor
Probe Type
set to
A: Electrode Probe Type
Temperature Sensor
Select the type of temperature sensor used: Pt100, Pt1000, Balco 3K or None.
Enable Calibration
Select to enable sensor calibration.
Yes
Select to disable sensor calibration and all associated frames.
No
Return to main menu.
CONFIG. SENSORS
See Section 5.4.
CONFIG. ALARMS
or – continued below.
Redox ORP
– continued on next page.
pH