ABB AX416 User Manual page 62

...7 CALIBRATION
...7.3 Factory Settings
-----
Cal. Output 1
16000
O1: Adjust 4mA
7200
O1: Adjust 20mA
Cal. Output 1
-----
Cal. Output 2
7200
O1: Adjust 20mA
Cal. Output 2
60
Calibrate Output 1
Note. When adjusting the 4 and 20mA outputs, the display reading is unimportant and is
used only to indicate that the output is changing when the
See below.
Cal. Output 2
Adjust 4mA
Use the and keys to set the milliammeter reading to 4mA.
Note. The analog output range selected in
the reading.
Adjust 20mA
Use the and keys to set the milliammeter reading to 20mA.
Note. The analog output range selected in
the reading.
See below.
Cal. Output 2
Monitoring pH
Redox (ORP)
Operating Page – see Section 2.3.
Dual Redox
pH/Redox (ORP)
Calibrate Output 2
Note. Output 2 calibration is identical to Output 1 calibration.
Option board fitted and analog features enabled – continued on next page.
Cal. Output 3
Option board fitted, additional features disabled – continued on next page.
Option Board
Option board not fitted – continued on next page.
Alter Fact. Code
Option board fitted and analog features enabled – continued on next page.
Cal. Output 3
Option board fitted, additional features disabled – continued on next page.
Option Board
Option board not fitted – continued on next page.
Alter Fact. Code
Monitoring pH
Redox (ORP)
Operating Page – see Section 2.3.
Dual Redox
pH/Redox (ORP)
and
(Section 5.6) does not affect
Configure Outputs
(Section 5.6) does not affect
Configure Outputs
keys are pressed.