Acyclic Data Exchange With The Fb Iol_Call - Siemens SIMATIC ET 200eco PN Operating Instructions Manual

Result
You have updated your ET 200eco PN device online with a new firmware version.
Starting in Version V6.0.0, if the ET 200eco PN I/O device was reset to the factory settings
before the firmware update, the port parameterizations are transferred and activated again
as a result of the neighborhood detection after the first connection is established between
the controller and the ET 200eco PN I/O device. In previous versions, the device name had
to be reassigned by selecting PLC > Edit Ethernet Nodes ... .
Note
You can also update the firmware using
the
6.3

Acyclic data exchange with the FB IOL_CALL

Function block"IOL_CALL"
For acyclic data exchange the function block "IOL_CALL" is available as a download for
controllers of the S7-400 and S7-300 families.
The function block supports you in the following tasks:
● Parameterization of an IO-Link Device during operation
● Executing IO-Link port functions
● Backing up/restoring IO-Link Device parameters
● Backing up/restoring IO-Link Master parameters
Procedure for configuring an IO-Link Master with S7-PCT
1. Copy the IO-Link CALL function block FB1 (including data block DB10) to a STEP 7
2. Use the IO-Link CALL function block FB1 as described in the demo project.
Reference
You can download the "IOL_CALL" function block and its description from the Internet
(http://support.automation.siemens.com/WW/view/en/33102519/133100).
ET 200eco PN
Operating Instructions, 06/2009, A5E01250250-04
STEP 7
Online Help.
project.
6.3 Acyclic data exchange with the FB IOL_CALL
HW Config
. You can find additional information in
Maintenance
73