Configuring; Configuring Et 200Eco Pn - Siemens SIMATIC ET 200eco PN Operating Instructions Manual

Configuring

4.1

Configuring ET 200eco PN

Requirements
You will need
Introduction
ET 200eco PN is included in the hardware catalog of
Procedure
1. Start SIMATIC Manager.
2. Create a new project.
3. Configure the ET 200eco PN with
4. Double-click on the technology module at slot 1 of the ET 200eco PN in the configuration
5. Save the configuration, or download it to the IO Controller.
Prerequisite for the GSD file
You will need a GSD file, available for download from the Internet
(http://support.automation.siemens.com/WW/view/en/10805292/133100).
ET 200eco PN family:
gsdml-v2.2-siemens-et200eco"date format yyyymmdd".xml
Configuring ET 200eco PN on PROFINET IO using
1. Start
2. In the next dialog box, select the GSD file to install, and confirm with "OK". Result: ET
3. The rest of the procedure is as described in the Programming with STEP 7
See also
For further information, refer to the
ET 200eco PN
Operating Instructions, 06/2009, A5E01250250-04
STEP 7
Version V5.4, SP4 or higher and, if necessary, HSP.
table and set the parameters.
STEP 7
and call up the Options > Install New GSD File menu command in
Config
.
200eco PN is displayed in the hardware catalog, PROFINET IO folder.
(http://support.automation.siemens.com/WW/view/en/18652056) manual.
HW Config
HW Config
.
STEP 7
STEP 7
Online Help.
4
STEP 7
after the start of
HW
.
61