Changing Print Position Adjustment Options - Fujitsu DL3700 Pro User Manual

USING SETUP MODE
CHANGING PRINT
POSITION ADJUSTMENT
OPTIONS
5 - 3 4
#05 Chapter 5
6. Do either of the following:
• Select another function, or
• Exit setup mode, saving your changes.
For details on other functions, see the other sections in this
chapter. To exit setup mode and save your changes, make sure
that the red cursor is positioned under SAVE/END, then
press the FONT button or the MENU button.
When you print using ruled paper, you often want to adjust the print
position so that the print sits properly on the ruled lines. The
ADJUST function allows you to:
• Set top-of-form position
• Fine-tune top-of-form position
• Fine-tune left print start column (left margin)
• Adjust for accumlative line spacing error in a page
The first three items are provided separately for cut single sheets and
continuous forms. The last item is available for single sheets only.
The top edge of your paper is the physical top of the page. The logical
top of the page, as "understood" by the printer when loading paper,
is called the top-of-form. Printing starts at this position. Note that
printing actually starts at the position obtained by adding the
following:
• Top-of-form, default = 1 inch (25.4 mm)
• Top margin specified by your software
• Printer TOP-MRG (top margin setting), default = 1 line
Table 5.5 describes the ADJUT items and options. Items are listed in
the order they are printed. The procedure for changing top-of-form is
described after Table 5.5.
34
User's Manual
11.08.1998, 23:03 Uhr