Closing The Housing - Fantasea Line FG9X Instruction Manual

6. Once the camera is inserted inside the housing, push the housing mode dial back down, so it
touches the camera mode dial.
7. If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
on the left side of the camera, in the slot midway up between the two rubber shock absorber
mounts, where it doesn't interfere with proper housing operation. It is important to make sure
that the silica gel pack doesn't stick out, or else it might interfere with the watertight seal of the
housing.

CLOSING THE HOUSING

1. Turn the housing Mode Control Dial till the Auto
shooting mode symbol is positioned at the left
(figure #13). Make sure not to accidently turn this
control any further before closing the housing.
2. Turn the latch so that the small red tab located on
the latch is pointed towards the front side of the
housing (figure #14).
3. Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
Then firmly press the back door against the forward section of the housing.
4. Turn the latch clockwise until the latch clicks. The small red tab should then be pointed towards
the bottom of the housing (figure #15).
www.fantasea.com | www.canondive.com
Figure #14
19
AUTO
Figure #13
Figure #15
FG9X Housing Instruction Manual 20160409