Closing The Housing - Fantasea Line FG7X II A M16 Instruction Manual

4. If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
on the left side of the camera, in the slot midway up between the two rubber shock absorber
mounts, where it doesn't interfere with proper housing operation. It is important to make sure
that the silica gel pack doesn't stick out, or else it might interfere with the watertight seal of the
housing.

CLOSING THE HOUSING

1. Turn the latch dial so that the small red tab located on the latch is pointed towards the front side
of the housing (image #11).
2. Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
Then firmly press the back door against the forward section of the housing.
3. Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #12).
4. Gently try pulling the back door away from the front door. If the housing is properly closed, it should
be impossible to open the back door.
5. Visually inspect the black O-ring through the transparent back door for proper closure. Make
sure it isn't twisted or out of the groove and that no foreign matter has been caught in the seal,
such as secure lines, sand, grit, hairs or any other foreign substance.
Image #11
17
FG7X II A M16 Housing Instruction Manual 20191218
Image #12