Closing The Housing - Fantasea Line FRX100 VI Instruction Manual

4. If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
on the left side of the camera, in the slot midway up between the two rubber shock absorber
mounts, where it doesn't interfere with proper housing operation. It is important to make sure
that the silica gel pack doesn't stick out, or else it might interfere with the watertight seal of the
housing.

CLOSING THE HOUSING

1. Turn the housing Control Dial till the Auto
shooting mode symbol is positioned at the
left (image #11). Make sure not to accidently
turn this control any further before closing
the housing.
2. Turn the latch dial so that the small red tab
located on the latch is pointed towards the front side of the housing (image #12 on the following
page).
3. Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
Then firmly press the back door against the forward section of the housing.
4. Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #13 on the following page).
17
MOISTURE DETECTOR
FRX100 VI Housing Limited Edition - Instruction Manual 20181003
Image #10
Image #11