Closing The Housing - Fantasea Line FG7X III R Instruction Manual

CLOSING THE HOUSING

1. If making use of the Hybrid Vacuum Safety System, turn the vacuum system on using the power If making use of the Hybrid Vacuum Safety System, turn the vacuum system on using the power If making use of the Hybrid Vacuum Safety System, turn the vacuum system on using the power
switch on the Signal Board prior to closing the housing
System").
2. Turn the latch dial so that the small red tab located on
of the housing (image #12).
3. Carefully close the back door of the housing, pushing it against the front door Carefully close the back door of the housing, pushing it against the front door, while making sure Carefully close the back door of the housing, pushing it against the front door
there is nothing sticking out of the housing or impairing the smooth closure of the back door. there is nothing sticking out of the housing or impairing the smooth closure of the back door there is nothing sticking out of the housing or impairing the smooth closure of the back door
Then firmly press the back door against the forward section of the housing.
4. Turn the secure dial clockwise till the lock dial Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #13). towards the bottom of the housing
5. Gently try pulling the back door awa Gently try pulling the back door away from the front door. If the housing is properly closed, it should
be impossible to open the back door. be impossible to open the back door.
6. Visually inspect the black O-ring
sure it isn't twisted or out of the groove and that no foreign matter has been caught in the seal sure it isn't twisted or out of the groove and that no fo
such as secure lines, sand, grit, hairs or any other foreign substance.
prior to closing the housing (see section "Hybrid Vacuum Safety
small red tab located on the latch is pointed towards the fro
door against the forward section of the housing.
Image #12
y from the front door. If the housing is properly closed, it should
ring through the transparent back door for proper closure.
sand, grit, hairs or any other foreign substance.
(see section "Hybrid Vacuum Safety
is pointed towards the front side
reign matter has been caught in the seal,
FG7X III R Housing Instruction Manual
18
should then be pointed
Image #13
for proper closure. Make
Instruction Manual 20200220