Closing The Housing - Fantasea Line FA6000 Instruction Manual

that the lens cannot be installed on the camera prior to inserting it into the housing, as the lens
is too large to be fully inserted inside the housing port hole. In such cases, the lens should be
installed on the camera after the camera has been inserted into the housing. The lens port
should be mounted on the housing only after the lens has been installed. Follow the steps
below:
a. Prepare the housing as described in the section "Preparing the Housing", only without
mounting the lens port.
b. Prepare the camera as described in the section "Preparing the Camera", only without
installing the lens on the camera.
c. Follow the instructions provided above in this section to install the camera (without the
lens) inside the housing.
d. Once the camera is installed, the lens can be mounted on the camera through the
housing lens port hole (image
#31). Align the white dot on the
lens with the one marked on the
camera, attach the lens to the
camera and turn it clockwise until
it clicks.
e. Mount the lens port on the
housing (see section "Installing
and Removing Lens Ports").
f. To remove the camera and lens
from the housing, follow the
instructions provided at the end of
the section "Removing the Camera
from the Housing".

CLOSING THE HOUSING

1. Turn the latch dial so that the small red tab located on the latch is pointed towards the front side
of the housing (image #32 on the following page).
2. Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
Then firmly press the back door against the forward section of the housing.
3. Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #33 on the following page).
Image #31
FA6000 Housing Instruction Manual 20190204
28