Introduction; Purpose Of The Operating Instructions; Additional Resources; Document And Software Version - Danfoss VLT AQUA FC 202 Operating Instructions Manual

Introduction

1 1
1 Introduction

1.1 Purpose of the Operating Instructions

These Operating Instructions provide information for safe
installation and commissioning of the frequency converter.
The Operating Instructions are intended for use by
qualified personnel.
Read and follow the Operating Instructions to use the
frequency converter safely and professionally, and pay
particular attention to the safety instructions and general
warnings. Keep these Operating Instructions available with
the frequency converter at all times.
®
VLT is a registered trademark.

1.2 Additional Resources

Other resources are available to understand advanced
frequency converter functions and programming.
•
The VLT
detail on working with parameters and many
application examples.
•
The VLT
information about capabilities and functionality to
design motor control systems.
•
Instructions for operation with optional
equipment.
Supplementary publications and manuals are available
from Danfoss. See www.danfoss.com/BusinessAreas/DrivesSo-
lutions/Documentations/VLT+Technical+Documentation.htm
for listings.

1.3 Document and Software Version

This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Please send
suggestions via email to
techcom_change_request@danfoss.com, including a
reference to the document version.
Table 1.1 shows the document version and the
corresponding software version.
Edition
MG20MBxx
Table 1.1 Document and Software Version
4
Operating Instructions
®
Programming Guide provides greater
®
Design Guide provides detailed
Remarks Software version
Replaces MG20MAxx
Danfoss A/S © Rev. 05/2014 All rights reserved.

1.4 Product Overview

1.4.1 Intended Use
The frequency converter is an electronic motor controller
intended for:
•
Regulation of motor speed in response to system
feedback or to remote commands from external
controllers. A power drive system consists of the
frequency converter, the motor, and equipment
driven by the motor.
•
System and motor status surveillance.
Depending on configuration, the frequency converter can
be used in standalone applications or form part of a larger
appliance or installation.
The frequency converter is allowed for use in residential,
industrial, and commercial environments in accordance
with local laws, standards, and emission limits as described
in the Design Guide.
Single phase frequency converters (S2 and S4) installed
in the EU
The following limitations apply:
•
Units with an input current below 16 A and an
input power above 1 kW are only intended for
professional use in trades, professions, or
industries and not for sale to the general public.
•
Designated application areas are public pools,
public water supplies, agriculture, commercial
buildings, and industries. All other single phase
units are only intended for use in private low-
voltage systems interfacing with public supply
only at a medium or high voltage level.
•
Operators of private systems must ensure that
the EMC environment complies with IEC
610000-3-6 and/or the contractual agreements.
NOTICE
In a residential environment, this product can cause
radio interference, in which case supplementary
mitigation measures may be required.
2.2x
Foreseeable misuse
Do not use the frequency converter in applications, which
are non-compliant with specified operating conditions and
environments. Ensure compliance with the conditions
specified in chapter 8 Specifications.
MG20MB02