Mains Supply 1X380-480 V Ac - Danfoss VLT AQUA FC 202 Operating Instructions Manual

Specifications

8.1.3 Mains Supply 1x380-480 V AC

Type designation
Typical shaft output [kW]
Typical shaft output at 240 V [hp]
IP21/Type 1
IP55/Type 12
IP66/NEMA 4X
Output current
Continuous (3x380-440 V) [A]
Intermittent (3x380-440 V) [A]
Continuous (3x441-480 V) [A]
Intermittent (3x441-480 V) [A]
Continuous kVA at 400 V [kVA]
Continuous kVA at 460 V [kVA]
Maximum input current
Continuous (1x380-440 V) [A]
Intermittent (1x380-440 V) [A]
Continuous (1x441-480 V) [A]
Intermittent (1x441-480 V) [A]
8 8
Maximum pre-fuses [A]
Additional specifications
Maximum cable cross-section for mains, motor, and brake
2
[mm ]] ([AWG])
Estimated power loss
4)
Efficiency
Table 8.6 Mains Supply 1x380-480 V AC - Normal Overload 110% for 1 Minute, P7K5-P37K
2) The 3 values for the maximum cable cross-section indicate single core, flexible wire, and flexible wire with sleeve, respectively.
3) The typical power loss is at normal load conditions and expected to be within
conditions).
Values are based on typical motor efficiency. Lower efficiency motors will also add to the power loss in the frequency converter and vice versa.
If the switching frequency is raised from nominal, power losses may rise significantly.
LCP and typical control card power consumption is included. Further options and customer load may add up to 30 W to the losses. (Though
typically only 4 W extra each for options for slot A or B, or for a fully loaded control card).
Although measurements are made with state-of-the-art equipment, some measurement inaccuracy must be allowed for (
4) Measured using 5 m screened motor cables at rated load and rated frequency.
48
Operating Instructions
3) at rated maximum load [W]
Danfoss A/S © Rev. 05/2014 All rights reserved.
P7K5 P11K
7.5 11
10 15
B1 B2
B1 B2
B1 B2
16 24
17.6 26.4
14.5 21
15.4 23.1
11.0 16.6
11.6 16.7
33 48
36 53
30 41
33 46
63 80
10 (7) 35 (2)
300 440
0.96 0.96
± 15% (tolerance relates to variations in voltage and cable
P18K P37K
18.5 37
25 50
C1 C2
C1 C2
C1 C2
37.5 73
41.2 80.3
34 65
37.4 71.5
26 50.6
27.1 51.8
78 151
85.5 166
72 135
79.2 148
160 250
50 (1/0) 120 (4/0)
740 1480
0.96 0.96
± 5%).
MG20MB02