Specifications; Electrical Data; Mains Supply 1X200-240 V Ac - Danfoss VLT AQUA FC 202 Operating Instructions Manual

Specifications

8 Specifications

8.1 Electrical Data

8.1.1 Mains Supply 1x200-240 V AC

Type designation
Typical shaft output [kW]
Typical shaft output at 240 V [hp]
IP20/Chassis
IP21/Type 1
IP55/Type 12
IP66/NEMA 4X
Output current
Continuous (3x200-240 V) [A]
Intermittent (3x200-240 V) [A]
Continuous kVA at 208 V [kVA]
Maximum input current
8 8
Continuous (1x200-240 V) [A]
Intermittent (1x200-240 V) [A]
Maximum pre-fuses [A]
Additional specifications
Maximum cable cross-section (mains, motor, brake)
2
[mm ] ([AWG])
Estimated power loss
Efficiency 4)
Table 8.1 Mains Supply 1x200-240 V AC - Normal Overload 110% for 1 Minute, P1K1-P22K
2) The 3 values for the maximum cable cross-section indicate single core, flexible wire, and flexible wire with sleeve, respectively.
3) The typical power loss is at normal load conditions and expected to be within
conditions).
Values are based on typical motor efficiency. Lower efficiency motors will also add to the power loss in the frequency converter and vice versa.
If the switching frequency is raised from nominal, power losses may rise significantly.
LCP and typical control card power consumption is included. Further options and customer load may add up to 30 W to the losses. (Though
typically only 4 W extra each for options for slot A or B, or for a fully loaded control card).
Although measurements are made with state-of-the-art equipment, some measurement inaccuracy must be allowed for (
4) Measured using 5 m screened motor cables at rated load and rated frequency.
44
Operating Instructions
3)
at rated maximum load [W]
Danfoss A/S © Rev. 05/2014 All rights reserved.
P1K1 P1K5 P2K2 P3K0
1.1 1.5 2.2 3.0
1.5 2.0 2.9 4.0
A3 - - -
- B1 B1 B1
A5 B1 B1 B1
A5 B1 B1 B1
6.6 7.5 10.6 12.5
7.3 8.3 11.7 13.8
2.4 2.7 3.8 4.5
12.5 15 20.5 24
13.8 16.5 22.6 26.4
20 30 40 40
0.2-4 (4-10)
44 30 44 60
0.98 0.98 0.98 0.98
± 15% (tolerance relates to variations in voltage and cable
P3K7 P5K5 P7K5 P15K
3.7 5.5 7.5 15
4.9 7.5 10 20
- - - -
B1 B1 B2 C1
B1 B1 B2 C1
B1 B1 B2 C1
16.7 24.2 30.8 59.4
18.4 26.6 33.4 65.3
6.0 8.7 11.1 21.4
32 46 59 111
35.2 50.6 64.9 122.1
60 80 100 150
10 (7) 35 (2) 50 (1/0)
74 110 150 300
0.98 0.98 0.98 0.98
± 5%).
P22K
22
30
-
C2
C2
C2
88
96.8
31.7
172
189.2
200
95 (4/0)
440
0.98
MG20MB02