Ip Configuration; Advanced Configuration - Extron electronics DVS 304 Series User Manual

IP Configuration

The IP Configuration menu displays the IP address of the unit, the Subnet mask, and
Gateway IP address.
Figure 18.
To change an IP address, do the following:
1.
2.
3.
4.
The IP configuration menu "times out" and saves changes if there is no activity for more
than 10 seconds.

Advanced Configuration

The following flowchart provides an overview of the
submenus and the options for each setting.
IP
CONFIG
MENU
ADVANCED
NEXT
CONFIG
AUTO MEMORY
NEXT
NEXT
<OFF> ON
Auto Memory
When set to on, the unit
automatically saves the
input and picture control
settings for inputs 2 and 4.
Figure 19.
MEMORY
PRESETS
MENU
IP I 196.168
NEXT
CONFIG P 254.254
View IP address
of the unit.
IP Configuration Menu
Press and hold the Input 4 and Next buttons simultaneously for 2 seconds. This
introduces the IP Setup mode.
Change the flashing octet selection by using the Adjust vertical ({) knob. Change the
address by using Adjust horizontal ([) knob.
Press the Next button to select another address to set up (subnet mask or gateway
IP).
Press the Menu button to save and exit.
AUTO IMAGE BLUE MODE
NEXT
<OFF> ON <OFF>
Auto imaging
Blue mode
When auto image is on,
When set to on, only the
the unit automatically
sync and blue video
sizes and centers each
signals are passed to the
new input.
display
ENHANCE MODE
REFRESH LOCK
NEXT
<OFF>
<OFF> ON
Refresh Lock Enhance Mode
When set to on, the When set to on, the
vertical ouptut rate will automatic gain control of
lock on to the incoming the input signal is
vertical refresh rate. enabled.
Advanced Configuration Menu
S 255.255
NEXT
M 000.000
View the subnet mask
of the unit.
Advanced Configuration
AUTO SWITCH
NEXT
ON <OFF> ON
Auto switching
The unit switches to the
highest numbered input,
which as a signal present
when auto switching is on.
TEST PATTERN
NEXT
ON OFF
Test patterns
• Off
• Crop
• Alternating pixels
• Color bars
DVS 304 Series • Operation
G 000.000
NEXT NEXT
M 000.000
View gateway IP address
of the unit.
RGB DELAY
NEXT NEXT
0.0 sec.
RGB delay
Can be set from 0 to 5.0
seconds in 0.5 steps.
OSD LABEL
NEXT
2 sec.
OSD label duration
Can be set from 0 OFF
(no OSD) to 5 seconds in
1 second steps.
18