Table of Contents
Advertisement
Remote
Configuration and
Control
This section describes the connections through which the DVC RGB-HD A can be
configured and controlled remotely via SIS commands and the Product Configuration
Software (PCS), as well as the available commands and screen selections. Topics include:
•
•
•
•
Communication Port
The DVC RGB-HD A can be remotely controlled via a host computer or other device (such
as a control system) that is connected to the rear panel USB Config port. With a USB
connection, you can configure and control the DVC using SIS commands or the PCS
software.
See
Using SIS Commands
SIS commands consist of one or more characters per command field. They do not require
any special characters to begin or end the command character sequence. When the DVC
determines that a command is valid, it executes the command and sends a response to the
host device. Each converter response to an SIS command ends with a carriage return and
a line feed (CR/LF = ] ), which signals the end of the response character string. A string is
one or more characters.
DVC-initiated Message
When power is cycled to the DVC (or at initial power-up) while the unit is connected to
the computer, the converter responds by sending the following message to the host. No
response is required from the host.
©Copyright 20
20nn is the year, and
Communication Port
Using SIS Commands
Product Configuration Software (PCS)
Firmware Loader
Connecting for USB Control
nn
, Extron Electronics DVC RGB-HD A, V
is the firmware version number.
Vn.nn
on page 8 to connect to the USB port.
n
DVC RGB-HD A • Remote Configuration and Control
nn
]
.
, 60-1614-01
11
Advertisement
Table of Contents
