Table of Contents
Advertisement
•
SDI Field Flip — This control allows the swapping of odd and even lines of the SDI
fields. It is disabled if the currently selected input is not in SDI format.
•
Output Configuration — To configure the resolution, refresh rate, sync format,
or sync polarity of an output, select the desired values from the respective drop-down
list.
•
EDID Emulation — To set an EDID (an output resolution with refresh rate), select
the applicable EDID from the drop down menus.
•
PIP Audio Follow — This option of the I/O Configuration tab assigns
audio to either the main image or the PIP image.
Advanced Settings Tab
The Advanced Settings tab allows advanced functions to be configured. These
include test pattern selection, RGB delay setting, and advanced functions.
Figure 38.
•
Test Pattern — Select any of the three test patterns to aid setting up an output
display device. A small thumbnail of the pattern is shown on the tab. Select
where a test pattern is not needed
•
RGB Delay — Adjust this slider to set RGB delay from 0 to 5.0 seconds
(in 0.5 second intervals).
•
Advanced Functions — Within this section Executive Mode, Blue Mode, Auto
Switching, Enhanced Mode, Auto Memories, and Refresh Lock can be turned on or
off by selecting the check boxes.
Status Bar
The status bar appears at the bottom of the SPPCP screen. It displays information about
the current status of the application as well as that of the device. It shows unit connected,
connection type (IP address or comm port), current user permission level (for example,
administrator), and any error information. If connected via Telnet, then the IP address or
unit name of the device are displayed. If connected via serial port, the baud rate and port
number are displayed. Error information appears for 5 seconds in the status bar and then
is replaced by connection and device information.
The Advanced Settings Tab Window
Off
DVS 304 Series • SPPCP
63
Advertisement
Table of Contents
