Table of Contents
Advertisement
•
Restore Configuration... — Select this to restore a saved DVS configuration
from a PC. A secondary window opens allowing a choice of which folder to restore
the files from. A pop-up confirmation window opens allowing the action to be
completed or cancelled.
•
File Manager — Select this to load the Extron IP Link
This is used in uploading and downloading files to and from IP Link-enabled devices,
including the DVS.
NOTE: This option becomes enabled when the File menu is accessed after
installing File Manager. In order to use this option, download the IP Link File
Manager application at
•
Exit — Select this to exit the control program. This disconnects and closes the
SPPCP.
Options menu
Click on this to open a drop-down menu displaying two
selectable options: Show Splash Screen, and
Display Errors on Status Bar.
•
Show Splash Screen — Select this to show the Extron Signal Processing
Products Control Program splash screen upon startup. Deselected, the program
opens immediately at the Select Connection Type window.
•
Display Errors on Status Bar —
Select this
to display any operation errors on the status
bar at the bottom of the window.
Tools menu
Click on this to open a drop-down box displaying
nine selectable options: Data View/Trace Window...
Sync Scaler to Matrix Switcher..., System
Settings..., Reset (has a secondary drop down box),
and Update Firmware....
•
Data View/Trace Window... — Select this to open a
separate window in which the transmit and receive (Tx/Rx)
data between the control software on the host PC and the
DVS can be viewed in ASCII format (see figure at right).
During data transmission and receipt, the data tracer window
is constantly updated.
Click
to save the Data trace in a log file format.
Save
Click
to erase all the data in the data tracer window.
Clear
To close the window, click
corner of the window.
•
Sync Scaler to Matrix Switcher — Select this to open a
secondary window. Within that window enter the IP address of the
matrix switcher to which the DVS is connected. If required enter the
password, then click Connect to Matrix. Select the output
number from the Matrix Output to DVS drop-down list and
click Take. The Matrix Status section displays the matrix
output that is being monitored and the tied input. The
DVS Input #4 section displays the current status of the input
being used.
www.extron.com.
or the
in the top right
Close
X
File Manager application.
®
DVS 304 Series • SPPCP
56
Advertisement
Table of Contents
