Input Configuration - Extron electronics DVS 304 Series User Manual

Input Configuration

The following flowchart provides an overview of the
and the options for each setting.
NOTE: Only inputs 2 and 4 offer selectable video types. From the
Configuration
the input video types for Inputs 2 and 4. The SDI input (where applicable) can be
assigned to any input from the I
Input 1 video type
Input 1 can only input composite video, other video types are not selectable.
Input 2 video type
Rotate either the
Input 2 submenu to select the appropriate video format (composite, S-video, YUVi, YUVp/
HDTV, YUV Auto) for input 2.
When input 2 is set to
sets the input accordingly. The default is YUVi video.
Input 3 video type
Input 3 can input only S-video, no other video types are selectable for this input. Using the
Input Configuration
Input 4 video type
Rotate the
submenu to select the appropriate video format (composite, S-video, RGBcvS, YUV,
4
YUVp/HDTV, RGB scaled, RGB pass-through, Auto detect).
NOTE: RGB pass-through signals (at the native rate without additional processing) are
available on analog outputs only. The DVI output is disabled for RGB pass-through.
For DVS 304 DVI models, input 4 has an EDID emulation feature (see
for EDID values).
When input 4 is set as
whenever it detects an input type change. The default is RGB scaled.
SDI input (SDI IN)
Rotate either the
in the
SDI Input
assigned to inputs 1, 2, 3, 4, or none (*). The default is none.
NOTE: When the SDI input is no longer assigned to an input, either because it has
been assigned to a new input or is set to "none", the input reverts to the last video
type that was assigned to it.
SDI de-interlacer options
Rotate either the
SDI Deinter
the SDI input is displayed with a significant amount of jaggies, use this setting to flip the
odd and even fields when de-interlacing the incoming SDI signal. The default is
menu, pressing the
nput Configuration
Adjust horizontal
, the scaler detects if YUVi or YUVp/HDTV is applied and
YUV Auto
menu.
([) or
Adjust horizontal
, the scaler will switch to the new configuration
Auto Detect
Adjust horizontal
submenu to select the input # for the SDI input. The SDI input can be
Adjust horizontal
submenu to set the appropriate de-interlacing method (Standard or Flip). If
Input Configuration
key successively displays submenus with
Next
menu.
([) or ({) knob while in the
Adjust vertical
({) knobs while in the
Adjust vertical
([) knob or
Adjust vertical
([) or
Adjust vertical
DVS 304 Series • Operation
submenus
Input
Input
table on page 15
({) knob while
({) knob while in the
.
Standard
13