Start - HP 1650B Programming Reference Manual

STARt

STARt
Note 4
Command Syntax:
Example:
System Commands
6-36
The STARt command is a run control command that starts the logic
analyzer running in the specihed run mode (see RMODe). The STARt
command is on the same level in the command tree as SYSTem; therefore,
it is not preceded by :SYSTem.
The STARt command is an Overlapped Command. An Overlapped
Command is a command that allows execution of subsequent commands
while the device operations initiated by the Overlapped Command are still
in progress.
OUTPUT XXX;":START"
command
HP 1650B/HP 16518
Programming Reference