HP 1650B Programming Reference Manual page 108

System Commands
6-34
The SYStem:SETup command configures the logic analyzer module as
defined by the block data sent by the controller.
The SYStem:SETup query returns a block of data that contains the
current configuration to the controller.
There are three data sections which are always returned:
(These are the strings which would be included in the section header.)
.
"1650 OISP *
.
"1650 OISPE"
Additionally, the following sections may also be included, depending on
what's available:
"SYMBOLS A w
.
"SYMBOLS B u
.
"SPA DATA A"
.
"SPA DATA
.
"INVASM A "
.
"INVASM B "
.
"COMPARE
command/query
HP 1650B/HP 16518
Programming Reference