Ese - HP 1650B Programming Reference Manual

*ESE

*ESE
Note u
Command Syntax:
where:
Example:
Common Commands
(Event Status Enable)
The *ESE command sets the Standard Event Status Enable Register bits.
The Standard Event Status Enable Register contains a mask value for the
bits to be enabled in the Standard Event Status Register. A one in the
Standard Event Status Enable Register will enable the corresponding bit
in the Standard Event Status Register. A zero will disable the bit. Refer
to table 5-l for information about the Standard Event Status Enable
Register bits, bit weights, and what each bit masks.
The *ESE query returns the current contents of the enable register,
Refer to Appendix B for a complete discussion of status.
OUTPUT XXX;"*ESE 3 2 "
In this example, the *ESE 32 command will enable CME (Command
Error), bit 5 of the Standard Event Status Enable Register. Therefore,
when a command error occurs, the event summary bit (ESB) in the Status
Byte Register will also be set.
command/query
HP 1650B/HP 1651B
Programming Reference