HP 1650B Programming Reference Manual page 174

Command Syntax:
where:
c restart-qualifier >
expression 1 >
Examples:
12-14
The RESTart command selects the type of restart to be enabled during
the trace sequence. It also defines the global restart qualifier that restarts
the sequence in global restart mode. The qualifier may be a single term or
a complex expression. The terms A through H are defmed by the TERM
command. The meaning of INRange and OUTRange is determined by
the RANGe command.
Expressions are limited to what you could manually enter through the
Format menu. Regarding parentheses, the syntax definitions below show
only the required ones. Additional parentheses are allowed as long as the
meaning of the expression is not changed.
A detailed example is provided in figure 12-2.
The RESTart query returns the current restart specification.
:: = { ANYState
( e expression 1 > [{AND I OR} c expression2 > ]) I
:: = { c or-term1 > I <and-term1 > I < or-term2 > I c and-term2 > }
:: = { <or-term1 > [OR <or-term1 >I... I cand-term1 > [AND <and-term1 >I...}
:: = { cor_term2> [OR cor_term2>]...
: : = {A~B~C~D(INRangelOUTRange}
: : = { NOTA
: : = {EIFIGIH)
: : = {NOTEINOTFINOTGjNOTH}
OUTPUT XXX;":MACHINEl:STRACE:RESTART
OUTPUT XXX;" :MACHINEl:STRACE:RESTART
OUTPUT XXX;":MACHINEl:STRACE:RESTART
OUTPUT XXX;":MACHINEl:STRACE:RESTART
command/query
{OFF ) PERLevel
[AND <and_term2>]...)
OFF"
PERLEVEL"
AND INRANGE)"
HP 1650B/HP 16518
Programming Reference