The AUToscale command causes the current analyzer (machine) to
machine is not a timing analyzer, the AUToscale command is ignored.
execution of subsequent commands while the logic analyzer operations
initiated by the Overlapped Command are still in progress. Command
overlapping can be avoided by using the *OPC and *WAI commands (see
the chapter "Common Commands") in conjunction with AUToscale.
When the AUToscale command is issued, existing timing analyzer
Note @
configurations are erased and the other analyzer is turned off.
Command Syntax:
Example:
OUTPUT XXX;":MACHINEl:AUTOSCALE"
command
HP 1650B/HP 16518
Programming Reference