Figure 3-11: Wlan And Wwan Card Slot Locations; Figure 3-12: Connecting Rf Cable - IEI Technology IVS-300 User Manual

IVS-300 Embedded System

Figure 3-11: WLAN and WWAN Card Slot Locations

Line up the notch on the WLAN/WWAN module with the notch on the slot. Slide
Step 5:
the WLAN/WWAN module into the slot at an angle of about 20º.
Secure the WLAN/WWAN module with the retention screw previously removed.
Step 6:
Connect the RF cable(s) to the antenna connector(s) on the WLAN/WWAN
Step 7:
module (Figure 3-12).

Figure 3-12: Connecting RF Cable

Remove the nut and washer from the SMA connector at the other end of the RF
Step 8:
cable.
Insert the SMA connector to the antenna connector hole on the rear panel.
Step 9:
Secure the SMA connector by inserting the washer and tightening it with nut.
Step 10:
Page 23