Test The Tilt Sensor Operation; Test Elevated Drive Speed; Test The Pothole Guards - Genie GS-1930 Operator's Manual

Operator's Manual
Inspections

Test the Tilt Sensor Operation

Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
59 Fully lower the platform.
60 Place a 2x4 or similar piece of wood under
both wheels on one side and drive the
machine up onto them.
61 Raise the platform approximately 7 ft / 2.1 m
from the ground.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should display
LL: Machine Tilted.
62 Press the drive function button
(if equipped).
63 Press and hold the function enable switch on
the control handle.
64 Move the control handle in the direction
indicated by the blue arrow, then move the
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
65 Lower the platform and remove both pieces of
wood.
36

Test Elevated Drive Speed

66 Raise the platform approximately 4 ft / 1.2 m
from the ground.
67 Press the drive function button
(if equipped).
68 Press and hold the function enable switch on
the control handle.Slowly move the control
handle to full drive position.
Result: The maximum achievable drive speed
with the platform raised should not exceed
0.72 ft / 22 cm per second.
If the drive speed with the platform raised exceeds
0.72 ft / 22 cm per second, immediately tag and
remove the machine from service.

Test the Pothole Guards

Note: The pothole guards should automatically
deploy when the platform is raised. The pothole
guards activate limit switches that allow the
machine to continue to function. If the pothole
guards do not deploy, an alarm sounds and the
machine will not drive or steer.
69 Raise the platform.
Result: When the platform is raised 4 ft / 1.2 m
from the ground, the pothole guards should
deploy.
70 Press on the pothole guards on one side, and
then the other.
Result: The pothole guards should not move.
71 Lower the platform
Result: The pothole guards should return to
the stowed position.
GS-30 • GS-32 • GS-46 • GS-47
Sixth Edition • Ninth Printing
Part No. T107026