Test The Outrigger Function (Gs-3232) - Genie GS-1930 Operator's Manual

Sixth Edition • Ninth Printing
72 Place a 2x4 or similar piece of wood under a
pothole guard.
73 Raise the platform.
Result: Before the platform is raised 7 ft /
2.1 m from the ground, an alarm should sound.
The platform controls LED readout should
display PHS and the ground controls LCD
should display PHS: Pothole Guard Stuck.
74 Press the drive function button
(if equipped).
75 Press and hold the function enable switch on
the control handle.
76 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: The machine should not move forward
or backward.
77 Press the drive function button
(if equipped).
78 Press and hold the function enable switch on
the control handle.
79 Press the thumb rocker switch on top of the
control handle in the direction indicated by the
blue and yellow triangles on the control panel.
Result: The steer wheels should not turn left or
right.
80 Lower the platform.
81 Remove the 2x4 or similar piece of wood.
Part No. T107026
Use the button pattern on the platform
controls to determine which of these next
two function tests to perform.
Use this function test procedure if the decal on
your platform controls has these buttons.

Test the Outrigger Function (GS-3232)

82 Raise the platform.
Result: The platform should raise to 22 ft /
6.7 m and stop.
83 Fully lower the platform.
84 Press and hold the outrigger enable button.
85 Press and hold the outrigger extend button.
Result: The outriggers should extend. The
individual outrigger indicator lights will flash
green as the corresponding outrigger extends.
86 Continue pressing the outrigger enable, the
foot switch (if equipped) and the outrigger
extend buttons until all outrigger indicator
lights turn solid green and a long beep is heard
from the platform controls alarm. The machine
is now level. At this point, the drive and steer
functions are disabled.
Note: If the outrigger enable and extend buttons
are released too soon during extension, the
outrigger indicator lights will continue to flash
green, indicating the outriggers are not contacting
the ground.
GS-30 • GS-32 • GS-46 • GS-47
Operator's Manual
Inspections
37