Install Panel Cradles; Panel Cradle Operation - Genie GS-1930 Operator's Manual

Sixth Edition • Ninth Printing

Install panel cradles

1 Hang the panel cradle from the platform
toeboard. Hang them on the side of the
machine without the platform extension locks.
Position the cradles as far apart as appropriate
for the load.
2 Using the 2 bolts and nuts provided, install the
retainer bracket to the cradle as shown.
3 Repeat for the other panel cradle.
a toeboard
b panel cradle bracket
c 2 bolts and nuts
d retainer bracket
Part No. T107026

Panel cradle operation

1 Lift each panel restraint clamp and swing it
out.
2 Use two people to lift the panel. Place the top
edge of the panel under the clamp, lift up and
set the bottom edge of the panel in the panel
cradle bracket. The clamp should secure the
panel.
3 Use the hole in the panel cradle to secure
panels that are too small to fit under the clamp.
Use a cord or strap, and be sure the panel is
secure.
GS-30 • GS-32 • GS-46 • GS-47
Operating Instructions
Operator's Manual
65