Panel Carrier Assembly; Panel Restraints; Install The Restraints To The Rail - Genie GS-1930 Operator's Manual

Operator's Manual
Operating Instructions

Panel Carrier Assembly

Panel restraints

1 Install the panel clamp in the housing, using
springs and washers in the order shown.
Install the cotter pin under the lower washer.
2 Repeat for the second housing.
a
b
c
d
e
f
g
a panel clamp
b spring 1
c washer 1
d housing
e spring 2
f washer 3
g cotter pin
64

Install the restraints to the rail

1 Install the clamp and housing on the side of
the machine without the platform extension
locks. Position the clamps as far apart as
appropriate for the load.
2 Using the 6 bolts and nuts provided, install the
clamp and housing to the scissor lift rails.
Install bolts and nuts in the order noted.
3 Apply the warning decal to the front of each
panel cradle (if needed)
4 Repeat for the second clamp and housing.
a
b
c
a
b
c
d
e
f
g
h
GS-30 • GS-32 • GS-46 • GS-47
Sixth Edition • Ninth Printing
2 bolts and nuts - install first
2 bolts and nuts - install second
2 bolts and nuts - install third
housing with clamp
platform rail
cover plate
rail clamp
decal
g
f
e
d
Part No. T107026