Test The Function Enable Switch And The Up/Down Functions; Test The Drive Function Button - Genie GS-1930 Operator's Manual

Operator's Manual
Inspections
Use this function test procedure if the decal on
your platform controls has these buttons.
Test the Function Enable Switch and the
Up/Down Functions
39 Do not hold the function enable switch on the
control handle.
40 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: No functions should operate.
41 Press the lift function button.
42 Wait seven seconds for the lift function to time
out.
43 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: The lift function should not operate.
44 Press the lift function button.
45 Press and hold the function enable switch on
the control handle. Slowly move the control
handle in the direction indicated by the blue
arrow.
Machines equipped with foot switch: Press and
hold the foot switch and press and hold the
function enable switch on the control handle at the
same time.
Result: The platform should raise. The pothole
guards should deploy.
34
46 Release the control handle.
Result: The platform should stop raising.
47 Press and hold the function enable switch on
the control handle.Slowly move the control
handle in the direction indicated by the yellow
arrow.
Result: The platform should lower. The descent
alarm should sound while the platform is lowering.

Test the Drive Function Button

Use this function test procedure if the decal on
your platform controls has these buttons.
48 Press the drive function button
(if equipped).
49 Wait seven seconds for the drive function to
time out.
50 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: No functions should operate.
GS-30 • GS-32 • GS-46 • GS-47
Sixth Edition • Ninth Printing
Part No. T107026