How To Use The Safety Arm; How To Fold Down The Guardrails - Genie GS-1930 Operator's Manual

Operator's Manual
Operating Instructions

How to Use the Safety Arm

1 Raise the platform approximately 8 ft / 2.4 m
from the ground.
2 Rotate the safety arm away from the machine
and let it hang down.
3 Lower the platform until the safety arm rests
securely on the link. Keep clear of the safety
arm when lowering the platform.
After Each Use
1 Select a safe parking location—firm level
surface, clear of obstruction and traffic.
2 Lower the platform.
3 Turn the key switch to the off position and
remove the key to secure from unauthorized
use.
4 Charge the batteries.
62

How to Fold Down the Guardrails

GS-1530, GS-1930, GS-2032, GS-2632 and
GS-3232
The platform railing system consists of one fold
down rail section for the extension deck and one
section for the main deck. All sections are held in
place by four wire lock pins.
1 Fully lower the platform and retract the
platform extension.
2 Remove the platform controls.
3 From inside the platform, remove the two rear
extension deck wire lock pins.
4 From the rear of the extension deck railing,
fold down the front rail assembly. Keep hands
free of pinch points.
5 Replace the two removed pins back into each
side rail bracket.
6 At the rear of the main deck, remove the two
lower wire lock pins.
7 Carefully open the gate and move to the rear
step or the ground.
8 From the rear step or from the ground, fold
down the main deck railing assembly. Keep
hands free of pinch points.
9 Replace the two removed pins back into each
side rail bracket.
Note: To assist in the removal and replacement of
the wire lock pins, pull or push back on the railing
to compress the rubber bumpers.
GS-30 • GS-32 • GS-46 • GS-47
Sixth Edition • Ninth Printing
Part No. T107026